Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 112)

Defining an area for the first time
Calling up the area menu
X To switch on navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Navi Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Avoid Area Avoid Area and press W to
confirm.
If you have not previously blocked an area,
a menu appears.
X Select Using Map Using Map , From Memory From Memory or From From
Personal POIs Personal POIs and press W to confirm.
If you select Using Map Using Map , the map with the
crosshair appears.
If you select
From Memory From Memory or From From
Personal POIs Personal POIs , either the destination
memory or the list of categories for POIs
appears.
R Destination memory (
Y
page 63)
R List of categories for personal POIs
(
Y
page 79)
X Select the desired destination or personal
POI and press W to confirm.
X When the destination address is displayed,
select Cont. Cont. and press W to confirm.
The map appears.
The crosshair marks the center of the area
that is to be avoided.
X To scroll the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
X Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X
To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
You can also determine additional areas to be
avoided (
Y
page 110).
Defining further areas
Calling up the list of areas
X To switch on navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Navi Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
110
Additional settings
Navi
ga
tio
n