Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 59)

Carpool lanes may only be used under certain
conditions. Normally you can use these lanes
when two or more occupants are traveling in
the vehicle. However, there are lanes that can
only be used when three or four occupants
(e.g. in New York) travel in the vehicle. In
California, lone drivers can use a carpool lane
if their vehicle's emission level or fuel
consumption is below a fixed threshold.
Carpool lanes may be reserved for specific
times (e.g. during the peak period).
Carpool lanes are identified by HOV symbols
on special road signs and by markings on the
road. On the road signs, you may also see the
word CARPOOL CARPOOL . The lanes are arranged as a
separate lane next to the others or are built
as a physically separate lane.
Depending on the setting under
Number of Number of
Occupants in Vehicle Occupants in Vehicle , COMAND uses
carpool lanes when calculating the route.
COMAND then guides you in and out of
carpool lanes using visual and acoustic
driving directions.
X In the route settings menu, select Number Number
of Occupants in Vehicle: of Occupants in Vehicle: by turning
cVd the COMAND controller.
X Select 11 , 22 or More than 2 More than 2 by turning
cVd and press W to confirm.
A # dot indicates the current setting.
Destination input
Important safety notes
G WARNING
For safety reasons, only enter a new
destination when the vehicle is stationary.
You could otherwise be distracted from the
traffic conditions, cause an accident and
injure yourself and others.
Entering a destination by address
Introduction
When entering an address as the destination,
you have the following options:
R entering the state/province, city/ZIP code
and street
R entering the state/province, city and
center
R entering the state/province, city/ZIP code,
street and house number
R entering the state/province, city/ZIP code,
street and intersection
R entering the state/province, street, city
and house number
Destination input
57
Navi
ga
tio
n
Z