Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 101)

then save the home address without having
to start route guidance.
X Select Home Home , Work Work or Not Not Classified Classified and
press W to confirm.
In both cases, you will see the address book
either with the character bar or as a
selection list.
X Select an address book entry
(
Y
page 144).
X
To confirm the selection: press W the
COMAND controller.
If there is no existing home address,
COMAND saves the entry. You will see a
message and then the address menu with
the selected address. Start Start is highlighted
automatically.
If a home address has already been stored,
you will see a prompt asking you whether
the My Address My Address entry should be
overwritten.
X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , COMAND overwrites the
destination. You will see a message and
then the address menu with the selected
address. Start Start is highlighted
automatically.
If you select
No No , the list will appear again.
Selecting the home address for route
guidance
X Proceed as described under "Selecting a
destination from the destination memory"
(
Y
page 63).
Saving a destination
General notes
This function also stores the destination in
the address book.
When the address book is full, no destinations
can be saved in the destination memory. You
must first delete address book entries
(
Y
page 144).
After destination entry
X The destination has been entered and is
shown in the address entry menu
(
Y
page 58).
X Select Save Save by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
You can now select storing options
(
Y
page 100).
During route guidance
X
To show the menu: press W the COMAND
controller.
X Select Dest. Dest. in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X Select Save Save Destination Destination and press W to
confirm.
You can now select storing options
(
Y
page 100).
From the list of previous destinations
X
To show the menu: press W the COMAND
controller.
X Select Dest. Dest. in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X Select From Last Destinations From Last Destinations and
press W to confirm.
The list of last destinations appears.
X Select a destination by turning cVd the
COMAND controller and press W to
confirm.
The destination address is shown.
X Select Save Save and press W to confirm.
You can now select storing options
(
Y
page 100).
Destination memory
99
Navi
ga
tio
n
Z