Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 104)

Storing the crosshair position in the
list of previous destinations
A crosshair appears on the map if you have
moved the map manually (
Y
page 103). You
can store the crosshair position as a
destination in the list of previous
destinations.
X To show the menu: press W the COMAND
controller.
X Select Position Position in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X Select Save Crosshair Position Save Crosshair Position and
press W to confirm.
Deleting one of the previous
destinations
X To switch on navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Dest. Dest. in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X Select From Last Destinations From Last Destinations and
press W to confirm.
The list of last destinations appears.
X Select the desired destination and press
W to confirm.
The destination address appears.
X Select Delete Delete and press W to confirm.
A prompt appears asking whether the entry
should be deleted.
X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , the entry is deleted.
If you select No No , the process will be
canceled.
Map operation and map setting
General notes
Company logos displayed on the map are
trademarks of the respective companies and
used solely for the purpose of indicating the
locations of these companies. The use of such
logos on the map does not indicate approval
of, support of or advertising by these
companies for the navigation system itself.
Setting the map scale
: Set map scale as a number with unit
; Currently set map scale as indicated by
the needle on the scale bar
= New map scale
? Scale bar
Unit of measurement : in the COMAND
display depends on the selection made for the
instrument cluster, see the separate vehicle
Operator's Manual.
X To hide the menu: slide ZV the COMAND
controller and, when the Full Screen Full Screen
menu item is shown, press W.
X To call up the scale bar: as soon as you
turn cVd the COMAND controller, scale
bar = appears.
X Turn cVd until the desired scale is set.
102
Map operation and map setting
Navigation