Navi gati on, Destination input – Mercedes-Benz SLS-Class 2013 COMAND Manual User Manual
Page 69

Example: search results for the chosen category
COFFEE SHOP
:
Highlighted stopover, current distance
from vehicle position and name of
stopover
X
To select a category: select a category by
turning cVd the COMAND controller and
press W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of 60 miles(100 km) of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display.
The stopovers along the route are displayed
at the top of the list, sorted by increasing
distance from the vehicle's current position.
Below this, you will see the stopovers that
COMAND finds in the vicinity of the vehicle's
current position.
i
For stopovers that are not located along
the calculated route, the linear distance is
shown.
X
Select an intermediate stop by turning
cVd the COMAND controller and press
W to confirm.
The address entry menu appears, showing
the destination address.
X
To start route calculation: select
Start
Start
and press W to confirm.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm
OK
OK
by pressing W.
X
Select a different category.
Deleting a stopover
If a stopover has already been entered, you
can delete it.
X
To switch to navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Dest.
Dest.
in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X
Select
Stopover
Stopover
and press W to confirm.
X
Select
Delete Stopover
Delete Stopover
and press W to
confirm.
COMAND deletes the intermediate stop
and recalculates the route to the main
destination.
Entering waypoints
Introduction
You can map the route yourself by entering
up to two waypoints. The sequence of the
waypoints can be changed at any time.
i
An intermediate stop is always between
the current position of the vehicle and the
first waypoint.
Creating waypoints
X
To switch to navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X
Select
Dest.
Dest.
in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Destination input
67
Navi
gati
on
Z
- SLK-Class 2013 COMAND Manual SL-Class 2013 COMAND Manual M-Class 2013 COMAND Manual GLK-Class 2013 COMAND Manual GL-Class 2013 COMAND Manual G-Class 2013 COMAND Manual E-Wagon 2013 COMAND Manual E-Sedan 2013 COMAND Manual E-Cab 2013 COMAND Manual E-Coupe 2013 COMAND Manual CLS-Class 2013 COMAND Manual C-Sedan 2013 COMAND Manual C-Coupe 2013 COMAND Manual