Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 103)

will appear asking whether you wish to
overwrite the existing data.
X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , COMAND stores the data.
You can start route guidance to this address
directly from the address book
(
Y
page 146).
Deleting a destination or the home
address
X To switch to navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Dest. Dest. in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
X Select From Memory From Memory and press W to
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1: destination memory list with
the character bar: enter characters using
the character bar (
Y
page 34).
X
Option 2: destination memory list as
selection list: select a destination by
turning cVd the COMAND controller and
press W to confirm.
You see the address data of the selected
entry.
X Select Delete Delete and press W to confirm.
A prompt appears asking whether you wish
to delete the destination.
X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , COMAND deletes the
destination. You will see a message to this
effect.
If you select No No , the process will be
canceled.
i If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which route calculation has
been started. If the memory is full, COMAND
deletes the oldest destination. You can also
save a destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
X Proceed as described in the "From the list
of previous destinations" section
(
Y
page 64).
Storing the vehicle position in the list
of previous destinations
X To switch on navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Position Position in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X Select Save Save Vehicle Vehicle Position Position and press
W to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
Previous destinations
101
Na
vigat
ion
Z