Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 67)

i “Last Destinations” memory
(
Y
page 101).
Entering a destination using the map
Calling up the map
X To switch to navigation mode: press the
Ø function button.
X To show the menu: press W the COMAND
controller.
X Select Dest. Dest. in the navigation system
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
: Current vehicle position
; Crosshair
= Details of the crosshair position
? Map scale selected
X Select Using Using Map Map and press W to confirm.
You see the map with the crosshair.
Display = depends on the settings selected
in "Map information in the display"
(
Y
page 106). You can see the current street
name if the digital map contains the
necessary data, You can see the coordinates
of the crosshair if the geo-coordinate display
is switched on and the GPS signal is strong
enough.
Moving the map and selecting the
destination
X
To scroll the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
X To select a destination: press W the
COMAND controller once or several times.
If COMAND is unable to assign a unique
address, you will see either the address
entry menu with the destination address or
a selection list.
X Select a destination by turning cVd the
COMAND controller and press W to
confirm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the Destination From Map Destination From Map entry.
X To start route calculation: select Start Start
and press W to confirm.
Destination input
65
Navigation
Z