Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 150)

The following can be used as a source:
R the mobile phone
R the memory card
R the USB device
R the Bluetooth ® Interface
Imported phone book entries are indicated in
the phone book by different symbols
(
Y
page 133).
X Search for an entry in the phone book on
the mobile phone d(
Y
page 133).
X Select the list symbol to the right of the
entry by sliding VY the COMAND
controller and press W to confirm.
X Select Save Entry Save Entry and press W to
confirm.
The Data saved. Data saved. message appears. The
phone book entry is now saved as an
address book entry.
The d symbol is replaced by the ¥
symbol.
Importing contacts
Information and requirements
You can import contacts (vCards) from the
memory card and a USB device into the
address book, or receive vCards via
Bluetooth ® .
i Up to 2500 entries can be imported into
the address book. A message notifies you
when the maximum number is reached.
You then have to delete existing entries in
order to import new entries (
Y
page 144).
Depending on the source of the contact data,
different requirements apply:
Source Conditions
memory card The SD memory card is
inserted (
Y
page 195). It
contains importable
contact details.
USB device The USB device is inserted
into the USB port
(
Y
page 195). It contains
importable contact details.
Requirements for receiving vCards via
Bluetooth ®
You can receive vCards from devices (e.g.
from a PC) that support the sending of vCards
via Bluetooth ® .
It is not necessary to authorize the device in
COMAND to do so.
Please bear the following in mind:
R Bluetooth ® must be activated in COMAND
and on the Bluetooth ® device, see the
operating instructions for the device.
R the Bluetooth ® device must be able to send
vCards via Bluetooth ® (see operating
instructions for the device).
R the Bluetooth ® device in the vehicle must
be switched on.
Importing from the memory card or USB
device
Entries imported from the memory card or
from a USB device have the ¯ symbol.
The following conditions must be fulfilled in
order to import vCards:
R vCards (vcf files) may be located in the main
directory or in folders. COMAND allows you
to select the relevant folders directly.
R vCards must have the file extension ".vcf".
i One vcf file may contain several vCards.
COMAND supports vCards in versions 2.1
and 3.0.
X Select Address Book Address Book in the address book
or, if the telephone basic menu is shown,
148
Using the address book
Telephone