beautypg.com

Navigation, Map operation and map setting – Mercedes-Benz SLS-Class 2013 COMAND Manual User Manual

Page 108

background image

Selecting map information

Map information in the display
During route guidance, you can have map

information shown at the bottom edge of the

display.

X

To show the menu: press W the COMAND

controller.

X

Select

Navi

Navi

in the main function bar by

sliding ZV and turning cVd the COMAND

controller and press W to confirm.

X

Select

Map Settings

Map Settings

and press W to

confirm.

The map settings menu appears.

X

Select

Text Information On Map

Text Information On Map

and

press W to confirm.

A # dot indicates the current setting.

X

Select

Arrival Time / Distance

Arrival Time / Distance

,

Current Street

Current Street

,

Geo-coordinates

Geo-coordinates

or

None

None

and press W to confirm.

X

To exit the menu: slide XVY the COMAND

controller.

Arrival time/distance to destination display
:

Icon for destination O

;

Distance to destination

=

Icon for estimated time of arrival Ñ

?

Estimated time of arrival Ñ

You can only see this display during route

guidance.
While moving the map, you will see additional

data, depending on the crosshair position, if

the digital map supports this data. This might

be a street name, for example.
During route calculation, or if the vehicle is

traveling on a non-digitized road, the linear

distance to the destination is shown. In this

case, the display will be grayed out.

Road display
:

Road names or numbers, e.g. for

highways

Geo-coordinate display
:

Current height above average sea level

(rounded to the nearest 10 m)

;

Current vehicle position: latitude

coordinates

=

Current vehicle position: longitude

coordinates

?

Number of GPS satellites currently being

used

There must be sufficient GPS reception for all

displays to be shown. If this is not the case,

the display will be grayed out. Height

display : may vary from the actual value,

because the navigation system uses the GPS

signals for the calculation.
During the "Move map" function, you will see

the geo-coordinates of the crosshair position.

106

Map operation and map setting

Navigation