Mercedes-Benz SLS-Class 2013 COMAND Manual - Manual (Page 197)

Inserting an SD memory card
X Insert the memory card into the slot on the
control panel until it engages in place. The
side with the contacts must face
downwards and point towards the slot.
The first 100 MP3 tracks are loaded. The
first MP3 track is then played. Further
tracks are loaded in the background; this is
indicated by an hourglass symbol.
If no MP3 tracks can be found, you will see
a message to this effect.
Ejecting an SD memory card
X
Press the memory card.
The memory card is ejected.
X Remove the memory card from slot.
Connecting a USB device
The USB port is located in the stowage
compartment in the center console.
Electrical consumption at this connection
must not exceed a continuous current of
500 mA. If the electrical consumption is
higher, use a separate source to provide
power for the USB device (e.g.
12 V power supply).
X
Connect the USB device (e.g. USB stick) to
the USB port.
The first 100 MP3 tracks are loaded. The
first MP3 track is then played. Further
tracks are loaded in the background; this is
indicated by an hourglass symbol.
If no MP3 tracks can be found, you will see
a message to this effect.
i Due to the wide range of USB devices
available on the market, playback cannot
be guaranteed for all brands of USB device.
Information about suitable USB devices
can be obtained from an authorized
Mercedes-Benz Center.
MP3 players must support Media Transfer
Protocol (MTP).
Switching to audio CD/DVD or MP3
mode
Inserting or connecting a medium
X Insert CDs/DVDs (
Y
page 192)
or
X
Insert an SD memory card (
Y
page 195).
or
X Connect a USB device (
Y
page 195).
COMAND loads the medium inserted and
starts to play it.
Switching modes using the function
button
X
Press the h function button one or more
times.
By pressing the function button repeatedly,
you can change the operating mode in the
following order:
R audio CD/DVD/video DVD/MP3 CD/MP3
DVD in the DVD changer or single DVD
drive (disc mode)
R memory card mode
R MUSIC REGISTER
R USB storage device
R Media Interface or audio AUX mode
R Bluetooth ® audio mode
X Select an audio medium from the media list
(
Y
page 197).
Switching modes via the audio menu
X Select Audio Audio in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
The last active audio source is now
activated.
You can activate a different audio source
using the audio menu.
X Select Audio Audio by sliding ZV and turning
cVd the COMAND controller and press
W to confirm.
The audio menu appears.
Audio CD/DVD and MP3 mode
195
Aud
io
Z