Cisco 3.3 - Manual (Page 811)

F-25
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
Appendix F RDBMS Synchronization Import Definitions
Action Codes
Action Codes for Modifying Network Configuration
Table F-6 lists the action codes for adding AAA clients, AAA servers, network
device groups, and proxy table entries. Transactions using these codes affect the
configuration displayed in the Network Configuration section of the HTML
interface. For more information about the Network Configuration section, see
Chapter 4, “Network Configuration” .
178 SET_PERMIT_DENY_
UNMATCHED_IOS_
COMMANDS UN|GN, V1 Sets unmatched Cisco IOS command behavior. The
default is that any Cisco IOS commands not defined
via a combination of Actions 174 and 175 will be
denied. This behavior can be changed so that issued
Cisco IOS commands that do not match any
command/command argument pairs are authorized:
GN = "Group 1"
V1 = "permit"
or
UN = "fred"
V1 = "deny"
The first example will permit any command not
defined by Action 174.
179 REMOVE_ALL_IOS_
COMMANDS UN|GN This action removes all Cisco IOS commands defined
for a particular user or group.
210 RENAME_GROUP GN,V1 Renames an existing group to the name supplied in
V1.
211 RESET_GROUP GN Resets a group back to the factory default.
212 SET_VOIP GN, V1 Enables or disables Voice over IP (VoIP) support for
the group named, as follows:
• GN = name of group
• V1 = ENABLE or DISABLE
Table F-5 Action Codes for Modifying TACACS+ and RADIUS Group and User Settings (continued)
Action
Code
Name Required Description