Cisco 3.3 - Manual (Page 288)

Chapter 7 User Management
Advanced User Authentication Settings
7-42
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
To configure and enable the Cisco Aironet RADIUS attribute to be applied as an
authorization for the current user, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-4 .
The User Setup Edit page opens. The username being added or edited is at the top
of the page.
Step 2 Before configuring Cisco Aironet RADIUS attributes, be sure your IETF
RADIUS attributes are configured properly. For more information about setting
IETF RADIUS attributes, see
Setting IETF RADIUS Parameters for a User,
page 7-38 .
Step 3 In the Cisco Aironet RADIUS Attributes table, select the [5842\001]
Cisco-Aironet-Session-Timeout check box.
Step 4 In the [5842\001] Cisco-Aironet-Session-Timeout box, type the session timeout
value (in seconds) that Cisco Secure ACS is to send in the IETF RADIUS
Session-Timeout (27) attribute when the AAA client is configured in Network
Configuration to use the RADIUS (Cisco Aironet) authentication option. The
recommended value is 600 seconds.
For more information about the IETF RADIUS Session-Timeout attribute, see
Appendix C, “RADIUS Attributes” , or your AAA client documentation.
Step 5 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.