Configuration-specific user group settings – Cisco 3.3 User Manual
Page 206
Chapter 6 User Group Management
Configuration-specific User Group Settings
6-16
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
Note
Up to 5 characters are allowed in the to x sessions box.
c.
Select the period for which the session quota is effective from the following:
•
per Day—From 12:01 a.m. until midnight.
•
per Week—From 12:01 a.m. Sunday until midnight Saturday.
•
per Month—From 12:01 a.m. on the first of the month until midnight on
the last day of the month.
•
Total—An ongoing count of session, with no end.
Step 5
To save the group settings you have just made, click Submit.
For more information, see
Saving Changes to User Group Settings, page 6-56
Step 6
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuration-specific User Group Settings
This section details procedures that you perform only as applicable to your
particular network security configuration. For instance, if you have no token
server configured, you do not have to set token card settings for each group.
Note
When a vendor-specific variety of RADIUS is configured for use by network
devices, the RADIUS (IETF) attributes are available because they are the base set
of attributes, used by all RADIUS vendors per the RADIUS IETF specifications.
The HTML interface content corresponding to these procedures is dynamic, its
appearance based upon the following two factors:
•
For a particular protocol (RADIUS or TACACS+) to be listed, at least one
AAA client entry in the Network Configuration section of the HTML
interface must use that protocol. For more information, see
.