ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 186)

7-10 ADS FlowShark Manual
Binding the nuts together with the washer in between
8. Install the stud into the tapped hole using the outer nut to
engage the wrench. Continue turning the nut clockwise until the
stud is seated at least ¾ inch deep in the hole.
Installing the stud into the hole in the manhole rim
9. Separate the nuts, and turn the inner nut until it is flush against
the rim.
10. Slide the washer against the inner nut, and turn the outer nut
toward the edge of the stud.