ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 107)

4-26 ADS FlowShark Manual
 SMA-to-TNC adaptor (ADS p/n 507173) for antennas with
the SMA connector
 Portable electric drill with assorted bit sizes (include ½-
inch and 3/8-inch bits)
 8-inch cable ties
 Post hole digger
 Shovel
 Sledge hammer
 7/16-inch nut driver
 Corbel drill with a ½-inch by 36-inch bit
 Hacksaw
 Commercial asphalt cold patch compound
 Electrical duct seal
 Rubber stretch tape
2. Mount the antenna to the pedestal:
Note: Some assembly may be complete upon delivery. If
this occurs, proceed to the next applicable step in the
installation process.
 Drill a ½-inch hole in the center of the horizontal top
portion of the bracket attached to the base of the pedestal.
Drilling hole in top bracket