Sindoh M403 - Manual (Page 21)

7
Before Use
WARNING
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil num rique de la classe [A] est conforme la norme NMB-003 du Canada.
WLAN Notice
Exposure to radio frequency radiation
The following notice is applicable if your printer has a wireless network card installed.
The radiated output power of this device is far below the FCC radio frequency exposure limits.
A minimum separation of 20 cm (8 inches) must be maintained between the antenna and any
persons for this device to satisfy the RF exposure requirements of the FCC.
Laser Notice
This machine is certified in the U.S. to conform to the requirements of DHHS21 CFR Subchapter
J for Class 1 laser products, and elsewhere is certified as a Class 1 laser product conforming to
the requirements of IEC 60825-1:2007.
Class 1 laser products are not considered to be hazardous. This machine uses two AIGaAs laser
diodes witha wave length of 775~800nm and an output of 15mW.
The laser system and machine are designed so there is never any human access to laser
radiation above a Class 1 level during normal operation, user maintenance or prescribed service
condition.