Sindoh M403 - Manual (Page 20)

6
Before Use
Energy Saver Mode
The device is designed for the energy saver mode.
The energy saver mode is the EPA sleep mode. In the energy saver mode that the device enters
while it is not used for a certain period of time, it reduces power consumption.
By default, the time to activate the energy saver mode is factory.
In the configuration mode, you can change the Energy Saver Mode time to 1 ~ 240 minutes.
If the energy saver mode time is low, you can save energy but the device responses slowly.
If the energy saver mode time is high, the device responses fast but more energy is used.
Deactivated Mode
Even in the deactivated mode, the device consumes power. To stop power consumption fully,
unplug the power cord
Total Energy Usage
It would be useful to calculate the Total energy usage of the device.
Since the electricity bill is charge by watt, to calculate energy use, you have to multiply time
spent in each mode with power consumption.
Total energy usage is the sum of energy use in each mode.
Wireless LAN Specification
This device may be affected by electromagnetic interference. So, it cannot be used for life
saving service.
Condensation
A dramatic change in ambient temperatures can create small water drops in and out of the
device. Remove water drops on the outer surface. To remove water drops inside the device,
open the platen or ADF and wait until they disappear.
EMC Notice
INFORMATION TO THE USER
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.