Sindoh M403 - Manual (Page 17)

3
Before Use
3. Safety Information
Plug the power cord to the wall outlet which is near the device, which is easily accessible and
properly grounded. Do not use or store the device in the wet or humid environment.
Caution Danger of Injury
- The product uses laser. The control, adjustment, or execution of the procedure not stated in
the document may cause exposure to harmful electromagnetic wave.
The product uses a printing media heating method so that gas may be emitted from paper
due to heating. In order to prevent the emission of harmful gas, the section addressing the
details on the selection of printing media in the operating instructions should be
understood.
Caution High Temperature on the Surface
- The inside of the device may be hot. Let the surface cooled down to prevent the damage
caused by a hot part. Touch it later on.
Caution Damage of Injury
- Follow below instructions to prevent personal injuries or device damage before moving
the device. Switch off the device and then unplug the power cord. Remove all cords and
cables from the device before moving it. Do not lift the optional feeder and device at the
same time. Lift the device first, and then use both side handles to lift the feeder. Use only
the power cord provided with this device or the one approved by the manufacturer.
Caution Danger of Electric Shock
- In case of accessing the system board or installing a memory option device after installing
the device, do the work after turning off the device and unplugging the power cord.
If another device is connected to the printer, turn off another device and separate the
cable connected to the printer.
Caution Danger of Electric Shock
- The design test of the product was passed and approved by using the component meeting
the strict international safety standards. The safety function of a part may not be clear.
The corresponding manufacturer is not responsible for the usage of another replacement
part.