Rockwell Automation DeviceNet Communications Module - Manual (Page 28)

4-2 DeviceNet Communications Module
4.2 Using the LCD OIM to Configure the
Module
Use the procedure in figure 4.1 to access the parameters on the
DeviceNet module using the LCD OIM (M/N MD4LCD-PNL,
MD4ALCD, or MD1CC). If you are unfamiliar with the operation of
the LCD OIM, refer to the OIM Quick Reference (D2-3508) for more
information.
4.3 Using RSNetWorx for DeviceNet
RSNetWorx for DeviceNet is a Rockwell Software application that
can be used to set up DeviceNet networks and configure connected
devices.
4.3.1 Setting Up RSLinx for RSNetWorx for
DeviceNet
To use RSNetWorx for DeviceNet, you must first set up a driver in
RSLinx. The driver provides a communications link between the
computer and DeviceNet network. See table 4.2 and figure 4.2 for
this procedure.
Figure 4.1 – Accessing the DeviceNet Parameters using the LCD OIM
MDI Devices
Device Select
DIAG PARAM DSEL MEM SEL
MDI Devices
MDCOMM-DNET
MD65 Linear List
Parameters
DIAG PARAM DSEL MEM SEL
Changed Params