Rockwell Automation 8720MC Drives Integration Manual - Manual (Page 19)

Publication 8720MC-IN002A-EN-P — December 2002
Commissioning Your 8720MC SERCOS Interface Drive 1-7
Configuring Your
1756-MxxSE SERCOS
Interface Module This procedure assumes that you have wired your 8720MC system and
have configured the 8720MC baud rate and optical power switches.
Note: For detailed configuration information, refer to the ControlLogix
Motion Module Setup and Configuration Manual (publication
1756-UM006x-EN-P).
To configure your 1756-MxxSE SERCOS interface module and create a
program including your 8720MC drive:
1.
2. Apply power to your ControlLogix chassis containing the
1756-MxxSE SERCOS interface module and open your RSLogix
5000 software.
3. Select New in the File menu. The New Controller window opens.
4. Provide/select the following New Controller attributes:
• Controller type
• File name
• ControlLogix chassis size
• ControlLogix processor slot
5. Select OK.
IMPORTANT
In order for the 8720MC to communicate with the
1756-MxxSE SERCOS interface module, (indicated by
the three LEDs on the 1756-MxxSE going solid
green) your RSLogix 5000 software must be version
11.0 or above.
If you have: Then:
Already configured your 1756-MxxSE
SERCOS interface module using the
ControlLogix Motion Module Setup
and Configuration Manual
(publication 1756-UM006x-EN-P)
Go to section
Applying Power to
Your 8720MC.
Not configured your 1756-MxxSE
SERCOS interface module
Go to step 2.
IMPORTANT
Refer to the ControlLogix Motion Module Setup
and Configuration Manual (publication
1756-UM006x-EN-P) for specific instructions and
troubleshooting.