Rockwell Automation 8720MC Drives Integration Manual - Manual (Page 108)

Publication 8720MC-IN002A-EN-P — December 2002
B-14 Using the Human Interface Module (HIM)
Using the Search Mode Search mode lets you search through the parameter list and display all
parameters that are not at the factory default values. You can also
search for links that are not the factory defaults.
To use Search mode:
1. From the status display, press any key. “Choose Mode” is shown.
2. Press the increment up key or the decrement down key to display
“Search” mode.
3. Press enter.
4. To search through the parameter list, press the increment up key
or the decrement down key. The HIM will search in ascending or
descending order depending on which key was depressed. The
display will scroll and stop at the next parameter or link which is
not at it’s default value.
5. Press the increment up key or the decrement down key again. The
HIM searches for the next parameter which is not at it’s default
value. In this way all parameters/links that are not at their factory
defaults can be displayed on the HIM.
6. Press the escape key to leave search mode and return to the next
higher level in the HIM logic tree.
Viewing the Fault Queue/
Warning Queue Control Status mode lets you view the fault queue. To view the fault
queue:
1. Press any key from the status display. “Choose Mode” is shown.
2. Press the increment up key or the decrement down key to show
“Control Status”.
3. Press enter to select Control Status
4. Press the increment up key or the decrement down key until
“Fault Queue” is displayed.
5. Press enter to select “Fault Queue”
6. Press the increment up key or the decrement down key until
“View Queue” is displayed.
7. Press enter to select “View Queue”