Rockwell Automation 7000 PowerFlex Medium Voltage (B Frame) Commissioning - ForGe (PanelView 550) - Manual (Page 51)

Rockwell Automation Publication 7000-IN006B-EN-P - May 2013 47
Commissioning the Drive Chapter 5
Drive Application Review To ensure trouble-free commissioning, it is necessary for all involved in the start-
up to familiarize themselves with the drive line-up and application. Do not
service the equipment without a clear understanding of the equipment’s
functional design, and the equipment’s particular application. If questions arise
that are not addressed within this manual, contact your local GMS office or
Medium Voltage Support directly.
Rockwell Automation Drive Line-up Drawings
Prior to performing any service work on the drive line-up, study and understand
the electrical and dimensional drawings provided with the equipment. These
drawings contain detailed information and instructions required for
commissioning and installation of the equipment including the following:
Dimensional Drawings
• Power cable termination locations
• Ground bus locations
• Shipping split locations
• Control and medium voltage power ratings
• Drive options
• Remote I/O protocol
• PLC options
• Motor and load specifications
• Drive power component selection ratings
• Heat exchanger ratings, connections
Electrical Drawings
• Contactor locations (electrically)
• Drive topology
• General notes
• Cable isolation ratings
• Symbol table
• Component designations
• Customer power and control wiring locations (electrically)
• Control and medium voltage power ratings
• Fuse ratings and locations (electrically)
Device Designations Color Designations Wire No. Designations SGCT Designations
Ribbon Cable Designations Location of Relay and
Contactor Contacts Location of Relays Drawing Location
References