beautypg.com

5 - commissioning the drive, Key steps to commission a pf7000 drive, Chapter 5 – Rockwell Automation 7000 PowerFlex Medium Voltage (B Frame) Commissioning - ForGe (PanelView 550) User Manual

Page 49: Commissioning the drive, Chapter

background image

Rockwell Automation Publication 7000-IN006B-EN-P - May 2013

45

Chapter

5

Commissioning the Drive

Key Steps to Commission a
PF7000 Drive

As a guide for a commissioning engineer, the major steps involved in the
commissioning of medium voltage PF7000 drives are outlined below in a
sequential order. For detailed instructions, always refer to the relevant PowerFlex
7000 drive’s user manual.

• Review the drawings and identify all sources of energy that apply to the

drive system and get better understanding of the application to which the
drive system is applied.

• Follow safety procedures and apply LOTO before working on the

equipment.

• Complete all power off checks and note down motor and drive nameplate

data.

• Apply control power and perform power on checks.
• Perform gating test.
• Program the drive after verifying the information on EDs and DDs against

the equipment nameplate data.

• Ensure the drive hardware and parameters are correct, such as HECS/CT

ratio and burden resistors installed in the drive are accurately programmed
in drive parameter settings

• Perform system test and verify operation of the drive and the associated

controls.

• Remove any jumpers used during system test.
• Inspect the drive line-up and ensure that no tools are left inside the

cabinets before closing them.

• Apply medium voltage and complete incoming line phasing checks and

take harmonic measurements.

• Perform DC test. Ensure that the Diagnostic Trend is setup and ready

before attempting the DC test.

• Perform Stationary Autotune tests (first 2 autotune tests).
• Bump the motor for rotation check.
• Complete Rotating Autotune tests (last autotune test) .
• Save the parameters in NVRAM and also transfer them from drive to

memory and also print the drive setup to your laptop.

• Start the drive in normal operation, print variables and capture waveforms.
• Complete commissioning documentation.