Rockwell Automation 7000 PowerFlex Medium Voltage (B Frame) Commissioning - ForGe (PanelView 550) - Manual (Page 35)

Rockwell Automation Publication 7000-IN006B-EN-P - May 2013 31
Initial Operator Interface Configuration Chapter 3
To change the duration of the delay, press [F2]. The current backlight delay is
highlighted. Adjust for values between 0 to 60 minutes. Zero (0) disables the
delay, keeping the light on indefinitely. Press
▲
or
▼
to change the value by 1-
minute increments. Press
◄
or
►
to change the value by 10-minute increments.
Press [Backspace] to abort the edit. Press [Enter] to save the changes.
Changing Contrast
Press [F3] to access contrast configuration ( Figure 20 ). Press
▲
or
▼
to change
the contrast value. To abort the change, press [Backspace]. Press [Enter] to save
the changes.
Figure 20 - Configuring display contrast
Setting Time
The clock controls the time stamp on drive information appearing on the alarm
summary screen.
Figure 21 - Setting the clock
To change the hour, press [F5]. Press
▲
or
▼
to increment the clock by 1 unit.
Press
◄
or
►
to increment the clock by ten units.