Rockwell Automation 47C626 AutoMax Programming Executive V4.2 - Manual (Page 199)

18Ć13
18.2.2 Displaying I/O Registers
You can display up to 16 registers on the screen at one time. The
Monitor I/O screen display is described in 18.2.1. To display a
register on the screen, follow the directions below:
1. Enter D" for Display" from the Monitor I/O menu shown in
figure 18.5.
2. If the register you want to display is in the local rack, enter L" for
Local and go on to the section entitled Displaying Local I/O". If
the register is in a remote rack, enter R" for Remote and go on
to the section entitled Displaying Remote I/O".
18.2.2.1 Displaying Local I/O
a. Enter the slot number of the module on which the register is
found.
b. Enter the register number.
c. Select the format of the display in the Value" field as follows:
D" for decimal
H" for hexadecimal
B" for binary
d. Type Enter" or to display the register.
18.2.2.2 Displaying Remote I/O
a. Enter the slot number of the Remote I/O master module (M/N
57C416) in the local rack.
b. Enter the drop number of the remote chassis in which the
module containing the register is located.
c. Enter the slot number of the module in the remote rack that
contains the register.
d. Enter the register number.
e. Select the format of the display in the Value" field as follows:
D" for decimal
H" for hexadecimal
B" for binary
f. Type Enter" or to display the register.