beautypg.com

Rockwell Automation 47C626 AutoMax Programming Executive V4.2 User Manual

Page 143

background image

9Ć5

9.2.2

Changing the Password in a Rack

The method outlined below changes the password directly in the

AutoMax Processor module without making any changes in the

AutoMax Executive software. In order to use this method, the

operating system must already be loaded onto the Processor (see

5.4.3). The Processor does not have to be stopped and the operating

system does not have to be reĆloaded when you use this method to

change the password. In addition, to use this method, you do not

need to know the current password to change it. Follow the steps

below to change the password:
1. Access the DOS prompt.
2. Insert disk 1 of the original or backup disks of the AutoMax

Executive software into drive A:

3. Type A:PWRACK /C=(full pathname to WIN95)\AUTOMAX.INI

For example, A:PWRACK /C=C:\WIN95\AUTOMAX.INI

4. When the system prompts you for the new password, enter the

password you have chosen. You may enter a for the

password. The user will then be required to enter a when

performing online menu operations that require the password.

5. When you are finished and back at the DOS prompt, type

EXIT. Note that you must exit the DOS session after

running PWRACK. Failure to do so may cause problems with

serial communication to the rack.

Note that with the above method for changing the password, the

edited password file resides only in the AutoMax Processor

module(s). The password can not be edited or read from the

Processor module(s).