Rockwell Automation 47C626 AutoMax Programming Executive V4.2 - Manual (Page 180)

15Ć2
15.1 Running an Individual Task
WARNING
THIS COMMAND OVERRIDES THE NORMAL STARTING SEQUENCE OF THE
APPLICATION TASKS, WHICH IS DETERMINED BY THE PRIORITY ASSIGNED
WHEN THEY ARE ADDED TO THE RACK. THE RUN ALL OPTION SHOULD
NORMALLY BE USED TO START TASKS. FAILURE TO OBSERVE THIS
PRECAUTION COULD RESULT IN BODILY INJURY.
Follow the directions below to put an individual task into run:
1. Select the task to be run from those displayed on the Online
menu. To select the task, use the up and down arrow keys to
move the >" pointer to the desired task.
2. Type the Enter" or key. The selected task will be shown
in reverse video.
3. Type R" to put the task into run. The task Status" field on the
display will show that the task is in RUN.
Note that UDC tasks can be run regardless of whether the PMI is
communicating with the UDC.
15.2 Running All Tasks in the Rack
To run all AutoMax and UDC tasks in the rack, including utility tasks,
using the procedure described in this section, all tasks in the rack
except utility tasks must be loaded in the rack. If this is not the case,
the screen will display an error message and no tasks will be put into
run.
Follow the directions below to put all tasks in the rack into run:
1. Do not select an individual task while at the Online menu.
Instead, type R" from the Online menu with no task selected.
This results in the display shown in figure 15.1.