Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 33)

Preface
ControlGuardian User’s Guide
3-2
Configuring Communication Hardware
The configuration information you specify depends on the communication hardware
you are using. For example, the required key sequences, numbered steps, and
applicable screens for configuring communication parameters for a 1784-KL
communications device are shown below:
Use function keys to configure
your system.
Press
Use keys
to highlight the
communication device.
Press
When you are finished, press:
Esc
to accept the configuration.
or
to abort the configuration and
return to the select file menu.
Enter
Enter
F3
¬
-
®
¯
°
Enter
to accept the configuration, the software
creates a communication device configuration file. This file contains the
parameters you configured for the communication device. Each device is
listed by the name and device description you entered in the communication
device configuration file list.
When you press
6 2 0
6 2 0
F1
Configure Program
F8
Communication
Hardware
Ins
Create
Main Menu
Parameters
Note Although the screens for each communication device will differ slightly than those
shown for the 1784-KL, the key sequences and numbered steps remain the same for
all of the communication devices supported by ControlGuardian. For information
on the specific configuration parameters for the communication device you are
using, locate your communication device in Table 3.A and proceed to the page
specified.