Rockwell Automation 9330-CC ControlGuardian User's Guide - Manual (Page 113)

Preface ControlGuardian User’s Guide
8-4
Use Ethernet WHO to display diagnostics for the local Ethernet link and for a
remote DH+ link that you reach through a Pyramid Integrator Ethernet Gateway (a
PI system with a 5820-EI module). The following example shows how to switch
from a local Ethernet link to a remote DH+ link.
This is a WHO active screen
for a local Ethernet link.
WHO Active
Main Menu
F4
Network
Diagnostics
F2
Press Esc
Press
¬
F9
Press
-
F1
®
¯
Enter the configuration information for the
PI Ethernet gateway. The bridge address
is the same number as the station number
for the EI module on the local Ethernet
WHO screen. For more information about
configuring an Ethernet device, see
chapter 3.
This is the WHO active screen for the
remote DH+ link attached to the
PI Ethernet gateway.
Application tip