Rockwell Automation 1785-Lx0C15 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 34)

1785-UM022C-EN-P - February 2008
1-22 Installing Your ControlNet PLC-5 Processor
Selecting Appropriate Cables This section lists information about:
• serial cables
• DH+ programming cables
• remote I/O cables
• ControlNet cables
For more information about cables, see the Enhanced and Ethernet
PLC-5 Programmable Controllers User Manual, publication
1785-6.5.12.
Serial Cables
You can make your own serial cables or purchase them from
Rockwell Automation.
The side label of the processor shows the following table, which
lists Channel 0 (serial port) pin assignments.
When used in a Class I, Division 2, hazardous
location, this equipment must be mounted in a
suitable enclosure with proper wiring method that
complies with the governing electrical codes.
WARNING
!
Pin RS-232C RS-422A RS-423 Pin RS-232C RS-422A RS-423
1 C.GND C.GND C.GND 14 NOT USED
TXD.OUT
- SEND COM
2 TXD.OUT
TXD.OUT
+ TXD.OUT 15
3 RXD.IN
RXD.IN
+ RXD.IN 16 NOT USED
RXD.IN
- REC COM
4 RTS.OUT
RTS.OUT
+ RTS.OUT 17
5 CTS.IN CTS.IN + CTS.IN 18
6 DSR.IN
DSR.IN
+ DSR.IN 19 NOT USED
RTS.OUT
- NOT USED
7 SIG.GND SIG.GND SIG.GND 20 DTR.OUT
DTR.OUT
+ DTR.OUT
8 DCD.IN
DCD.IN
+ DCD.IN 21
9 22 NOT USED
DSR.IN
- NOT USED
10 NOT USED
DCD.IN
- NOT USED 23 NOT USED
DTR.OUT
- NOT USED
11 24
12 25
13 NOT USED
CTS.IN
- NOT USED
The shading indicates that the pin is reserved.