Rockwell Automation 1785-Lx0C15 ControlNet PLC-5 Programmable Controllers User Manual - Manual (Page 143)

Publication 1785-UM022C-EN-P - February 2008
Index 7
terminating
1-17
Selectable Timed Interrupts (STIs)
using with ControlNet system
4-9
selecting the DH+ station address of
Channel 1A
1-11
setting the I/O chassis backplane
switches
1-9
addressing switches
1-9
EEPROM transfer switches
1-9
last state switch
1-9
processor memory protection switch
1-9
setting the I/O chassis configuration plug
1-10
SMAX
definition
P-3
Software
3-1
specifications
PLC-5
A-1
specifying the serial interface of
Channel 0
1-12
status
layout for the processor
B-1
Status File
D-1
I/O
description 2-18
status file
processor
B-1
status indicators
location of
on PLC-5/20C 1-3
on PLC-5/40C 1-4
PLC-5
5-1
using
5-1, 5-3
status words
I/O map entry
D-1
T
tap
1-21
connecting
1-17
definition of
P-3
using
1-17
terminator
definition of
P-3
troubleshooting ControlNet system
5-1
trunk cable
definition of
P-3
trunkcable section
P-3
U
UMAX
definition
P-3
Unscheduled Data Transfer
definition
2-4
unscheduled data transfer operations
2-4
unscheduled maximum node
definition
P-3
unscheduled non-discrete I/O data
transfer
2-4
unscheduled transfers
definition of
P-3
upload/download software projects
3-3
user control bits
processor status file
B-12
using ControlNet I/O Transfer (CIO)
instructions
4-3
using ControlNet Immediate Data I/O
instructions
4-6
using ControlNet Message (MSG)
instructions
4-1
using the ControlNet status indicators
5-3
using the general status indicators
5-1
using this manual
conventions used
P-4
intended audience for
P-1
introduction to
P-1
recommended preparation for
P-1
V
verification acitivities
3-4
verify keeper signature
3-4
verify scanner signature
3-4