Rockwell Automation 57RF RFID ICODE Handheld Interface User Manual - Manual (Page 36)

36 Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011
Chapter 4
Manually Saving the Persistent Registry
The RFID ICODE handheld interface internal memory consists of SDRAM and
Flash. Typically, any changes made to the RFID ICODE handheld interface
including file creation are temporarily stored in the unit’s SDRAM. You must
then copy the files from SDRAM to internal flash memory or a removable
compact flash card to store the information permanently.
Consequently, if you do not store the information to flash memory and the unit
loses power, all information stored in SDRAM will be lost. However, whenever
you make changes that affect the registry, such and changing settings in the
Control Panel or installing software, you can permanently store registry changes
without writing to flash memory by using the Persistent Registry.
To store registry information on the RFID ICODE handheld interface
permanently:
1. From the Start menu, select Programs>Tools>SaveReg.
2. The RFID ICODE handheld interface will begin saving the registry.
3. After you successfully save the registry, a message box will appear:
4. Click OK to close the message box.
Command Prompt Windows
The command prompt window allows you to execute limited MS-DOS
command line arguments (for example, CD SystemCF, Run TEST.BAT, etc.).
To open the Command Prompt window:
1. From the Start menu, select Programs>Tools>Command Prompt. The
Command Prompt window opens:
IMPORTANT The RFID ICODE handheld interface will also store registry information
every time you perform a suspend/resume operation.