Rockwell Automation 57RF RFID ICODE Handheld Interface User Manual - Manual (Page 11)

Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011 11
Chapter
2
Quick Start Guide
The Quick Start Guide will give basic instructions on how to use your new RFID
ICODE handheld interface.
Powering up the RFID
ICODE Handheld Interface 1. Charge the unit for a minimum of three hours prior to first use.
a. If you are using the wall charger and serial cable (57RF-HH-56IN,
57RF-HH-56US2):
i. Plug the power jack of the battery charger/power supply into the
corresponding cable connector as shown below.
Figure 1 - Power Jack
ii. Remove the rubber cover from the RS-232 connector on the bottom
of the RFID ICODE handheld interface. Plug the interface cable
into the connector.
iii. Plug the battery charger/power supply into a power outlet. The
Charge LED should turn on, indicating that the batteries are
charging.
Figure 2 - Power Outlet
b. If you are using the charging cradle (57RF-HH-56US1):
i. Plug the two-pin connector of the power supply into the back of the
charging cradle as shown below.
Figure 3 - Charging Cradle/Power Supply
Power Supply/Battery Charger
To Unit