JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 87)

87
11 Setup program
11.4.3 Editing receiver parameters
Procedure:
11.4.4 Transfer new parameters to the receiver
Procedure:
11.5 Customer-specific linearization
Customer-specific linearization (max. 40 grid points or 4th order polynomial) allows sensors to
be connected that are not defined by the factory default linearizations.
To activate the customer-specific linearization, ensure that "Potentiometer" or "Voltage" is con-
figured as the sensor type on the transmitter. The customer-specific linearization parameter
must be configured as "tAb1 to tAb4" in the channel-specific parameters on the receiver.
You can define the linearization in the E
DIT > C USTOMIZED LINEARIZATION menu.
Procedure:
Step Action
1 In the navigation tree, double-click to select the desired main parameter
of the receiver (e.g. channels).
The channel parameters appear.
2 Edit the desired parameters.
3 Confirm editing with "OK".
4 Save the parameters in the "File" menu with the "Save" function.
Step Action
1 In the "Data transfer" menu, select the "Data transfer to device" function.
The current parameters are transferred to the receiver.
2 In the "Data transfer" menu, use the "Disconnect connection" function to end communica-
tion between the setup program and receiver.
Step Action
1 Select one of the tables 1 to 4.
2 Select the linearization method – table (grid point) or formula (polynomial).
3 Edit parameters.
4 Exit the entry with OK.