JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 63)

63
8 Configuring the receiver
• Limit value 2
for alarm type 2 01.A2L 0 -9999 to +9999
Hysteresis
for alarm min.+max. 01.HYS 0 0.00 to 99.99
Difference from the limit values
for alarm deactivation
Alarm delay 01.ALd 0 0 to 999 s
Drag indicator, lower 01.Min -9999 to +9999 Display only, cannot be edited
Minimum value drag indicator,
automatic decimal point
Drag indicator, upper 01.MAX -9999 to +9999 Display only, cannot be edited
Maximum value drag indicator,
automatic decimal point
Reset
drag indicator 01.RES
0
1
Drag indicator:
do not reset
reset
Parameter Bottom
line
of dis-
play Top
line
of display Value range/selection 
TIP!
The "Customer-specific linearization", "Unit", "Scaling active", "Scale start", and "Scale end"
parameters are only relevant for the resistance transmitter, potentiometer, voltage, and pres-
sure transmitter types.
TIP!
If the "free text entry" is configured for the unit parameter, the corresponding text must be en-
tered with the setup program.