JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 49)

49
8 Configuring the receiver
8.1 Startup level (In)
The receiver channels are assigned to the transmitters in this level (linkedwith each other). This
can be done conveniently using the setup program, or manually via the keypad. The options
are described below.
Regardless of the method adopted, the following points must be noted:
•
Assign each transmitter ID to a transmitter only once, as the receivers cannot differentiate
between several transmitters that have the same ID.
• A transmitter ID may also only be linked once to each individual receiver. After receiving a
wireless telegram, the receiver checks the channels 1 to 16 until it finds a matching link. For
this reason, a second channel with the same link would not receive any input values.
If for some reason the actual value of a channel must be emitted on two analog outputs si-
multaneously, this channel must be configured in two analog outputs with a selector.
 Chapter 3.6 "Data flow diagram", page 22