JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 62)

8 Configuring the receiver
62
8.2.3 Channel-specific parameters
Channels 1 to 16
The following table shows the parameters of channel 1 that are to be set. The next table con-
tains the same setting options for channels 2 to 16.
Parameter Bottom
line
of dis-
play Top
line
of display Value range/selection 
Wireless telegram
timeout
(Wireless timeout) 01.Tmo 3 2 to 20 transmission intervals
Offset
(actual value correction) 01.OFF 0.00 -99.99 to +99.99
Filter time constant 01.dF 0 0 to 100 s
Decimal place 01.dP Auto
0
1
2 Automatic point
xxxx.
xxx.x
xx.xx
Customer-specific lin-
earization 01.Lin Lin
tAb1
tAb2
tAb3
tAb4 Linear
Table 1
Table 2
Table 3
Table 4
Unit
for resistance transmit-
ter, potentiometer, or
voltage transmitter types 01.Un1 0 0 to 16
(0 = none, mm, cm, m, ml, liters,
hl, m
3 , %, °C, °F, ohm, k ohm,
mV, kg, tonnes, free text entry)
Unit
for pressure transmitter
types 01.Un2 1 0 to 6
(0 = mbar, bar, kPa, MPa, psi, %,
free text entry)
Scaling active 01.Sca OFF OFF, on
Scale start 01.SLo 0 -9999 to +9999
Scale end 01.SHi 100 -9999 to +9999
Limit value alarm 1
• Alarm type 1 01.A1m OFF
LoAL
HiAL
No alarm
Min. alarm
(actual value < limit value 1)
Max. alarm
(actual value > limit value 1)
• Limit value 1
for alarm type 1 01.A1L 0 -9999 to +9999
Limit value alarm 2
• Alarm type 2 01.A2m OFF
LoAL
HiAL
No alarm
Min. alarm
(actual value < limit value 2)
Max. alarm
(actual value > limit value 2)