10 displaying and resetting a drag indicator – JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual User Manual
Page 79
79
10 Displaying and resetting a drag indicator
Procedure:
Step
Action
1
Hold the
key for > 2 s to leave the normal display (NA) and move to the parameter level
(PA).
In the bottom line, the display shows the first general parameter – the software version
(SWVER).
2
Hold the
key for > 2 s to jump to a channel-specific parameter.
In the bottom line, the display shows the 1st parameter for the 1st channel timeout of the
wireless telegram [wireless timeout (01.Tmo)].
3
Use the
key to browse to the lower drag indicator parameter (01.Min)
of the 1st channel.
In the top line, the display shows the minimum value of the 1st channel.
4
Use the
key to browse to the upper drag indicator parameter (01.MAX)
of the 1st channel.
In the top line, the display shows the maximum value of the 1st channel.
5
Use the
key to browse to the "reset drag indicator" parameter (01.RES)
of the 1st channel.
The display shows "0", which means that the drag indicator is active.
6
Use the
key to select the "reset drag indicator" parameter.
The "0" display flashes.
7
Use the
key to select the "reset drag indicator" parameter.
The display shows a flashing 1 in the top line.
This selection can be reversed using step 8.
8
Use the
key to select the "do not reset drag indicator" parameter.
The display shows a flashing 0 in the top line.
9
Hold the
key for > 2 s to apply the "reset drag indicator" function as in step 7 (or "do not
reset drag indicator" function as in step 8).
The display shows Stor (storage) for 0.25 s and then jumps to "reset drag indicator"
(01.RES).