JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 44)

7 Operating the receiver
44
7.1 Normal display (NA)
The normal display is active when the receiver is connected and the voltage supply activated.
The measured value of the first transmitter is visible in the top line of the LCD display.
The channel designation is visible on the left and the selected unit is on the right in the bottom
line of the LCD display. If more than five characters have to be displayed, the display automat-
ically switches to the ticker mode.
In the normal display, a maximum of 16 channels and their measured values or the signal qual-
ity of the transmitter signal received can be displayed.
7.2 Channels and their Display measured values
Linked channels available:
Figure 20: Display of all linked channels
The and keys can be used to display in succession all channels linked to transmitters
and their measured values either in an ascending or descending order.
No linked channels available:
Figure 21: Display when no linked channels are available
The „no Link“ note signals that there are no channels linked to transmitters.