JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 74)

9 Term definition
74
The parameter is only available for receivers with a hardware version of 1 or above, or with a
device software version that is equivalent to 03.01 or above.

Chapter 2.1 "Nameplate", page 9
 Chapter 11.5 "Customer-specific linearization", page 87
Unit for resistance transmitter types, potentiometer, or voltage
One of 16 units (17 units with device software version 04.01 and above) can be selected here.
The unit is shown in the receiver display.
The parameter is only available for receivers with a hardware version of 1 or above, or with a
device software version that is equivalent to 03.01 or above.

Chapter 2.1 "Nameplate", page 9
 Chapter 11.5 "Customer-specific linearization", page 87
Unit for pressure transmitter types
One of 7 units can be selected here. The unit is shown in the receiver display. In addition to this
unit, the numerical value for the pressure is also automatically converted here (except for "free
text entry").
The parameter is only available for receivers with a hardware version of 1 or above, or with a
device software version equivalent to 04.01 or above.

Chapter 2.1 "Nameplate", page 9
 Chapter 11.5 "Customer-specific linearization", page 87
Scaling active
Scaling is performed if the parameter is set to "On". The parameter is only available for device
software version 04.01 or above.
Scale start, scale end
For transmitters where the sensor type is configured as Resistance transmitter, Potentiometer,
Voltage, or Pressure, the input measuring range (e.g. 0 to 50 mV) can be scaled to a range de-
fined by the user (e.g. 0 to 250). The corresponding unit is configured with the Unit parameter.
The parameter is only available for receivers with a hardware version of 1 or above, or with a
device software version that is equivalent to 03.01 or above.

Chapter 2.1 "Nameplate", page 9
 Chapter 11.5 "Customer-specific linearization", page 87