JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 86)

11 Setup program
86
When using the USB/TTL converter, there is also the option to establish the connection via a
USB interface.
Procedure:
Establishing the communication without using the assistant
Procedure:
11.4.2 Reading out the current receiver parameters
Procedure:
Step Action
1 Start the setup program.
2 In the "Data transfer" menu, select the "Establish connection" function.
Once the setup program has started, the "device settings assistant" appears.
3 Select the receiver in "Device version" and confirm with "Next".
4 Select the PC communication interface "USB-TTL converter" and confirm with "Next".
5 Select the connected converter (e.g. USB <-> Serial (LID:...)) and confirm with "Next".
6 Select the device address (e.g. 1) and confirm with "Next".
7 Exit the assistant with "Finish".
The device list with the selected receiver appears.
8 Click the "Connect" button.
The device list closes, the assistant terminates, and the communication between receiver
and setup program is established.
Step Action
1 Start the setup program.
2 In the "Data transfer" menu, select the "Establish connection" function.
The device list with all entered devices appears.
3 Left-click the desired receiver to select it.
4 Click the "Connect" button.
The device list closes, the assistant terminates, and the communication between receiver
and setup program is established.
Step Action
1 In the "File" menu, select the "New" function.
The "device assistant" starts.
2 Select "Automatic detection and data transfer from the device" and confirm with "Next".
3 Exit the overview of the read out settings with "Finish".
The current settings are imported into the setup program.