JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 58)

8 Configuring the receiver
58
8.2.2 General parameters
Device information
Device data
Parameter Bottom
line
of dis-
play Top
line
of display Value range/selection 
Software version SWVER 01.01 Display only, cannot be edited
Hardware identification HArdw 0 to 15 Display only, cannot be edited
Error
(system error bits) Error 0 to 3 Display only, cannot be edited
= Save errors detected with
power ON
CAUTION!
Error (system error bit) indicates:
For bit 0 (0x01), the receiver has initialized the configuration data with the factory settings.
Please check the settings and reconfigure if necessary.
For bit 1 (0x02), the receiver has initialized the calibration data with the factory settings.
Recalibrate the receiver.
Parameter Bottom
line
of dis-
play Top
line
of display Value range/selection 
Temperature unit T-Uni °C °C
°F
Code for
startup level Cod.In 0 0 to 9999
No password request with 0
Code for
parameter level Cod.PA 0 0 to 9999
No password request with 0
Radio frequency RF.FrQ 868.4 868.4 MHz
Display only, cannot be edited
912.6
913.0
913.6
914.0
914.6
915.4
916.0
916.4
917.0
917.4 915 MHz
Ten frequencies can be config-
ured in the frequency band.
TIP!
The radio frequency change is only valid once the device has been restarted (power on/off).