JUMO 902931 Wtrans Receiver with Wireless Data Transmission Operating Manual - Manual (Page 51)

51
8 Configuring the receiver
Use this process if both the transmitters and the receiver are active. Each receiver registers all
transmitters that it receives but has not linked itself in a link list with a maximum of 25 entries.
This list is automatically generated. New transmitters are added automatically. If a transmitter
does not signal for a period of 10 minutes, it is removed from the list. When it is opened, this
list is "frozen". The ID received last is given first. It can be used to link the received transmitter
ID with the individual receiver channels as described below.
Procedure:
All channels can be linked with the received transmitter IDs in the manner explained above.
Step Action
1 Hold the key for > 2 s to change from the normal display to the startup level (In).
2 Select the channel of the receiver to be linked using the or key
(in Figure 25, channel 3).
3 Call up the link list with the key.
The link list is frozen and the transmitter IDs are sorted by time
at which they were received. The channel is displayed in the top line of the display (in the
example 3). The currently assigned transmitter ID flashes in the bottom line.
4 Use the key to select the transmitter ID to be linked.
The selected transmitter ID flashes.
5 Hold the key for > 2 s to link the transmitter ID to channel 3.
The selected transmitter ID stops flashing.
The "Link" information appears for 0.25 s in the bottom line of the display.
6 To return to the normal display, hold the key for > 2 s or use the 40 s key timeout.
The display returns to the channel that was displayed last in the normal display.