CCTV Camera Pros Geovision 8.4 Multicam Digital Surveillance System - Manual (Page 310)

294
Note: For GV-Net/IO Card V3.1 (Net/IO Card Mode), select the option of GV-NET/IO Card; for
GV-Net/IO Card V3.1 (I/O Box Mode) and GV-I/O Box 4 Ports, select the option of GVIO-USB(4); for
GV-IO Box 8 Ports, select the option of GVIO-USB(8), and for GV-I/O Box 16 Ports, select the option
of GVIO-USB(16).
[Input X] Click the Arrow buttons to select an Input to set up.
Figure 6-2
Name vice in the Name field.
ally open), NC (normally close)
onitor Input]
elect this option to use the input (sensors or detectors) to trigger recordings on
and
o activate computer alarm when the input is triggered. You can
d out the predefined alert (E-Mail/Hotline/SMS)
s,
(E-Mail/Hotline/SMS).
: Specifies a name for the input de „
„ Signal Type: Select a signal type for your input device: NO (norm
or Latch Trigger. Clicking the finger button can apply your selection to all input devices.
For details on Latch Trigger, see Latch Trigger later in this chapter.
[M
„ Rec Video: S
multiple cameras. Click the Arrow button to select which camera to record upon input trigger,
specify the recording duration.
„ Invoke Alarm: Select this option t
select the alarm sound from the drop-down list.
„ Invoke to Send Alerts: Select this option to sen
when the input is triggered. For e-mail alerts, see E-Mail Notification in Chapter 1; for hotline alert
see Hotline Notification in Chapter1; for SMS alerts, see Short Message Service in Chapter 10.
1st Right Arrow button: Appears when E-Mail is the predefined alert. Click the button to select
the camera(s) to take a snapshot on input trigger. The snapshot will be sent out by E-Mail.
2nd Right Arrow button: Sets the time to delay the activation of assigned alerts