Apple LiveType 2 - Manual (Page 122)

122 Chapter 9 Advanced Design Techniques
5 Add a new effect to the track.
6 Select the ending keyframe of the effect.
7 In the Effects tab of the Inspector, add the Slide parameter to the Active Parameters
stack. Double-click the Slide parameter and set the value to 100, which is a percentage
of the track’s length.
When you assign the Slide value to the ending keyframe, the beginning keyframe
defaults to a Slide value of 0.
8 While you’re still on the ending keyframe, set the Size parameter to 0.
9 In the Timing tab of the Inspector, set the Sequence value to 10, and choose From Right
from the Start pop-up menu.
Add parameters using the
Parameter pop-up menu and
the + button.
Change parameter values by
double-clicking an active
parameter.