Konica Minolta Magicolor 3300DN - Manual (Page 83)

Cleaning the Printer 75
Make sure any parts removed during cleaning are replaced before you plug in
the printer.
WARNING!
Turn off the printer, unplug the power cord, and disconnect all interface
cables before cleaning.
Be careful when cleaning the inside or removing paper jams, as the fuser
unit and other internal parts may become very hot. Either clean the
density sensor before use, or allow time after unplugging the printer
to allow the fuser unit to cool down.
WARNING!
The fuser unit is hot and can cause severe burns. When the
printer’s front cover is opened, the fuser unit temperature drops
gradually. Wait one hour after opening the front cover.
WARNING!
Do not spill water or detergent into the printer; the printer will be
damaged and an electric shock may occur.
Use Avoid
Exterior
A soft dry cloth to clean the
control panel. Sharp or rough implements (such as
wire or plastic cleaning pads); any liquid.
A soft damp cloth to clean the out-
side of the printer. Sharp or rough implements (such as
wire or plastic cleaning pads).
Mild neutral detergent to clean the
outside of the printer if stains
remain. (Always test any cleaning
solution on a small area of your
printer to check the solution's
performance). Abrasive or corrosive solutions that
contain solvents (such as alcohol or
benzine); aerosol or pump-sprayed
cleaners.
Interior
A soft dry cloth or cotton swab to
clean the density sensor. Vacuuming.
Pulling media too hard and tearing it.
Sharp implements (such as tweezers)