Konica Minolta Magicolor 3300DN - Manual (Page 114)

Solving Problems 106
The printer is
not receiving
data from the
computer. (The
Data indicator
doesn’t blink
after a file is
sent.) The printer is not on
line. Put the printer on line and verify that the
message window displays
IDLE .
The emulation has
been changed from
ESP to an emulation
that doesn’t match
the file you are
sending. Print a status page. For information about
the ESP mode, refer to the Crown Books.
The port setting is
incorrect. For Ethernet or parallel connections, set the
port to Enabled.
When the parallel
cable is set to Inter-
active (the default),
and the parallel
cable is unplugged
then plugged back
in, communication
was lost. Set the parallel cable to Non-
Interactive mode in the Administration/
Communications/Parallel/Mode menu.
Too many sta-
tus pages print. Your printer is set to
print the multiple-
page Advanced
Status Page instead
of the one-page
Standard Status
Page. Select the type of status page through the
Administration/Special Pages/
Status Page Type menu on the control
panel.
Symptom Cause Solution