Konica Minolta Magicolor 3300DN - Manual (Page 76)

Replacing the Fuser Unit 68
11
Close the covers , .
12
Continue with the media feed roller(s)
replacement. “How do I replace the
media feed roller(s)?” below.
How do I replace the media feed roller(s)?
1
Pull the media tray out of the printer
until it stops.
2
Hold the tray with both hands, lifting
slightly, and remove it from the printer.
Push the tabs of the media feed roller cover to open the cover.
The media feed rollers feed media from the
media tray(s) into the printer. When the media feed
rollers deteriorate, media may not feed
correctly from the media tray, resulting in media jams.
Replace the media feed roller in each 500-sheet media
tray each time you replace the fuser unit.
Three media feed rollers are included with the fuser unit. If you do not have a
high-capacity input feeder (HCIF), you will have one or two rollers left over.