Solving problems 105 – Konica Minolta Magicolor 3300DN User Manual
Page 113
Solving Problems
105
You hear
unusual noises.
The printer is not
level.
Put the printer on a flat, hard, level surface
not to exceed ±5° slant in any direction.
The media tray is not
installed correctly.
Remove the media tray that you are print-
ing from and reinsert it completely into the
printer.
There is a foreign
object stuck inside
the printer.
Turn off the printer and remove the object.
If you cannot remove it, contact Service.
Refer to the Service & Support Guide or
The printer
pauses
periodically.
The image unit
pauses to perform
an automatic
cleaning rotation
after every page of
one-page simplex
jobs and pages
longer than 14
inches (355.6 mm),
and between pages
of multipage jobs,
depending on the
amount of
processing required
between pages.
Wait. Printer automatically resumes.
This process is provided to ensure reliable
printer operation with optimum output
quality. See “What are the printer’s internal
cleaning cycles?” on page 73 for more
detailed information.
The printer
goes into
power-saving
mode.
The printer
automatically
switches to
power-saving mode
after one hour of
inactivity (default).
You can change the number of minutes
before the printer switches to power-
saving mode in the Administration/Engine/
Energy Saver menu.
You are unable
to access
Accounting in
CrownView.
The printer is not
turned on and
IDLE
.
Make sure the printer is on and
IDLE
appears in the control panel.
For more information about CrownView,
refer to the Crown Books.
You do not have a
hard disk installed.
Install a hard disk.
Symptom
Cause
Solution