Konica Minolta Magicolor 3300DN - Manual (Page 129)

Status, Error, and Service Messages 121
MEDIA JAM
DUPLEX
Media has jammed in
the duplexer. Locate and remove the
jam. Open and close the
front door to reset the
printer.
MEDIA JAM FEED
Media has jammed
while being pulled from
the specified tray.
MEDIA JAM FUSER
Media has jammed
leaving the fuser area.
MEDIA JAM
REGISTRATION
Media has jammed in
front of the imaging unit.
MEDIA TYPE
MISMATCH
The media detected in
the tray doesn’t match
the media size or type
setting. Change the media in the
tray or change the media
size or type setting
.
MISMATCH JAM Media has jammed near
the transparency sen-
sor. Locate and remove the
jam. Open and close the
front door to reset the
printer.
OUTPUT BIN FULL
The media has
exceeded the limit (such
as over 250 sheets of 20
lb [75 g/m
2 ] bond) in the
output bin.
Remove the media from
the output bin.
PRINTING STATUS
A status page is
printing. Wait until after the status
page prints and the mes-
sage clears.
PUT
PAPER IN
BIN
The Operator Control/
Chain Inputbins is set to
Off and the displayed
tray is empty. Refill it
with the specified size
media. <
SIZE> is the
media size detected by
the engine, and <
ANY>
is the empty tray.
Refill the tray with the
specified size media.
This message... means... do this...